Skip to content
  • There are no suggestions because the search field is empty.

Enabling Sensors on your Universal Control Box

If you've purchased Sensors after receiving your lift, you'll need to enable them



Using the keypad on the LOGO! controller...
  1. Press down arrow until you see either a date/time code or the I/O monitor (grid of numbers)
  2. press the 'ESC' key on the bottom left.
  3. Use the up and down arrow keys to scroll to Program menu item. Press the green key on the bottom right to select.
  4. Select Set Parameter in the menu.
  5. Scroll down to Hopper Sensors

  6. Select with the Green OK button, and scroll to on.

If you don't see Hopper Sensors in your Program, contact your Technical Brand Ambassador to receive an updated Universal Control Box program.

If you go back one menu, you will also be able to calibrate the Delay Timer. This will run the vacuum for another specified time to ensure all coffee has been lifted. You can increase or decrease this depending on your lift run length.