| Estimated Time | Less than 5 minutes |
|---|---|
| People Required | 1 |
| Difficulty | Easy |
| Tools Required | None |
Before You Begin
Ergo-fill lets you fill bags without the foot pedal. Instead, you use the funnel itself to tell the machine when to dispense the coffee. When you pull the funnel towards you, it presses a relay, this is the switch that tells the machine to dispense, and you will hear it click. The Ergo-fill is set with a single adjustment screw underneath the machine, next to the funnel, and you can do it by hand.
Check your machine has Ergo-fill. If it does not, you do not need this guide.
Switch off first if the machine is connected. If your Precision Fill Mini is already set up, switch off the power and the air supply before reaching underneath. If you are following the uncrate and assembly guide, nothing is connected yet, so you can go straight ahead.
If at any point you are unsure or uncomfortable, stop and contact Technical Service before continuing.
Step 1 — Check for the Click
Estimated time: Less than 1 minute | 1 person
Gently pull the funnel towards you, towards the front of the machine.
Listen for a click from the relay. If you hear it, the Ergo-fill is set and you are done. If you do not hear a click, move on to Step 2.
Step 2 — Adjust the Screw
Estimated time: Less than 5 minutes | 1 person
Find the Ergo-fill adjustment screw underneath the machine, next to the funnel.
Turn the screw in a little by hand. No tools are needed.
Pull the funnel towards you again to check for the click.
If it still does not click, turn the screw in a little more and check again. Repeat until you hear the relay click when you pull the funnel.
Do not use a tool to force the screw. If it will not turn by hand, or you cannot get the relay to click, stop and contact Technical Service.
What's Next
If you are setting up your machine for the first time, return to the Precision Fill Mini Uncrate and Assembly Guide and continue from Step 6.
If pulling the funnel stops triggering the click after it has been set, contact Technical Service so we can check it with you.